Artemis LED Crown Troubleshooting

Artemis LED Crown Troubleshooting

If your Artemis LED Crown isn't working the way you expect, check the steps below.

For setup and modes, see Using Your Artemis LED Crown.


The Crown won't start, or there's no light

Check each of these in order:

  1. Cable connected at both ends. The Crown will not run unless the cable is connected to both the headset and the remote controller. The two ends of the cable are different, so make sure each one is in the correct device, as shown in the diagram in your user manual.
  2. Headset worn on your head. The Crown has a safety sensor and only emits light when the headset is on your head. Position it so the fixation pad sits in the middle of your forehead.
  3. Remote powered on and a mode selected. Press the power button and wait for the voice message, then press a mode button.
  4. Battery level. If the red low-battery lamp is on, the battery is below 10%. Charge the remote (see below) and try again.

The lights on the remote are flashing

Some flashing is normal:

  • The white LED flashes when you power on.
  • The LED for your selected mode flashes while it runs.
  • The white LED flashes again five minutes before the session ends.

If the lights are behaving differently from this, or the Crown stops on its own, see "What to send us" below.

The remote won't charge, or the battery drains fast

  • The battery is in the remote controller, not the headset.
  • Use a 2A 5V USB adapter to charge the remote.
  • Never connect the adapter directly to the headset.
  • The green lamp blinks while charging and stays lit when full.

The remote is hot, or stops working

Stop using the Crown. Disconnect the remote from the headset and email us at i@artemismask.com. Please do not try to repair it yourself.

The cable is missing, damaged, or doesn't fit

Use only the cable that came with your Crown. Do not use a damaged cable. If the cable is missing, damaged, or the ends don't seem to fit your headset and remote, email us and we'll help.


What to send us if you still need help

Email i@artemismask.com with the details below, and we can start troubleshooting right away without extra back-and-forth:

  • Your order number
  • A short video showing the headset on your head, the cable connections, and the remote's lights and voice messages
  • Which adapter you used to charge the remote

If you notice any malfunction, please stop using the Crown until we've looked at it.

With Love & Light, The Artemis Team